M400 -100232 / Machine M632-208 Swing Arm ATC ( 24 Tools)
AuxKeys:
Aux 1 Key -
Aux 2 Key -
Aux 3 Key -
Aux 4 Key - Chip auger Motor Selection (Left/Right)
Aux 5 Key - Conveyor Chip REV
Aux 6 Key - Conveyor Chip FWD
Aux 7 Key - WorkLight
Aux 8 Key - Tool Index -
Aux 9 Key - Tool Index +
Aux 10 Key -
Aux 11 Key -
Aux 12 Key -
Aux 13 Key - Rear Chip Wash Key
Aux 14 Key - ATCOverride Key
CNC11 Parameters:
PARAMETER_6 - ATC enable - 1 = enable
PARAMETER_160 - Random or Non Random ATC
PARAMETER_161 - ATC Max Bins
PARAMETER_85 - Door Closed input #. 0 - disable
PARAMETER_170 - Keyboard Jogging. 1 - enable
PARAMETER_171 - Dual Chip Auger motors selection. 1 - enable
PARAMETER_175 - Chiller Off Timer
PARAMETER_179 - Lube timer - MMss - MM=off time in min, ss=lube pump time.
M-codes:
M3 (1)-Spindle CW
M4 (2)-Spindle CCW
M8 (3)-Flood On
M10(4)-Clamp
M7 (5)-Mist
M6 (6)-Tool Change
M21(7)-Chip Pump on
M22(7)-Chip Pump off
M18(10)-ATC Reset
M19(11)-Spindle Orient
M13(13)-Swing Arm Cycle with ATCOverride Key
M14(14)-Pot Down with ATCOverride Key
M15(15)-Pot Up with ATCOverride Key
M11(16)-Rotary Table Unclamp
M31(17)-Auger Forward
M32(18)-Auger Reverse
M33(19)-Auger Stop
M88(20)-Spindle thru tool coolant
NOTE Changes to keyboard jogging bmp needed. See MEM400+
"Invalid key" messages will need to be supressed
Function:
1. ATC Swing Arm
a. P6 = 1 to activate ATC stages and restart control+MPU11
b.
2. Door interlock
If door is open or not set correctly, control will be limited to slow jog only.
If door is open and MDI or program running, control will display WAIT FOR DOOR CLOSE message
and feedhold condition. End-user will have to close the door and press cycle start to resume.
After 10 seconds () control will fault with DOOR NOT LOCKED message (E-Stop condition)
a. P85 must be set to the door closed input number
b. P85 = 0 to disable doorinterlock stage and function.
c. DoorInterlock_Override_M (M136) can be set when probe is connected and Aux13 + Aux14
pressed at same time.
3. Dual Chip Auger
a. forward - Aux 5 and M31, M33 to Stop
b. reverse - Aux 6 and M32, M33 to stop
c. P171 = 1 to enable the chip auger 1 or 2 selection, Aux4Key is the selection key
4. Tool Thru Coolant
a. M88 - to turn it on. M89 - to turn it off
